VORTEX CLEANING GUN

The vortex gun is the fastest and easiest way to clean all automotive surfaces. It works with air compressor (6-9,2 bar) to blast cleaning solution into crevices you can’t reach by hand.
It cleans dashboards, door panels, steering wheel, fabric upholstery, carpet, floor mats and between the seats inside the car. It cleans fabric convertible tops, body seams, wheels and emblems on the exterior. There’s no need to scrub. The vortex cleaning gun does the hard work for you. The cone-shaped nozzle and oscillating tip create a tornado cleaning action that cleans hard and soft surfaces: dirt and grime are immediately released from the fabrics, carpets and solid surfaces.
You’ll see the liquid turning dirty as grime is released from the surface. Wipe with a microfiber towel. Then turn the dial to shut off the water and use the compressed air to dry the cleaned area.
Equipped with the filter for intake the detergents.
 
How to clean fabrics using a A-Vortice gun?

1. Remove coarse debris hoovering the interested area first and then proceed with the cleaning treatment.
2. Turn the liquid valve on vertical position before using the vortex gun.
3. Direct and maintain the diffuser within a distance of 3 to 10cm from the surface to treat. Completely push the trigger. Start to treat the surface with regular and overlapping movements.
4. After wetting the area, turn another time the liquid valve on horizontal position (closed) and use only the compressed air to dry the surface.

How to clean plastics, dashboards and solid surfaces?

1. It is recommended to regulate the air pressure at 5,5 bar.
2. Turn the liquid valve in vertical position before using the vortex gun. Nebulize on the surface to treat with regular and overlapping movement.
3. Let the detergent react for about 10-15 seconds.
4. Afterwards dry using the air, by closing the detergent top, turn it in horizontal position. Do always regular and overlapping movements and follow them using an absorbing microfiber cloth.

Advice: After each single use, immerge 5-10cm of the cone in a bucket with soapy water and push the trigger for 1-2 times, do this in order to quickly remove the dirt that builds up inside the cone. This easy and quickly procedure will avoid premature wear and tear of the rotating parts of your device!